Solve the engraving machine lettering is not smooth and knowledgeable

First of all, it may be because there is a gap between the x-axis and the y-axis of the engraving machine, which will cause the engraving machine to sway during engraving, so that the engraving caused by the deviation of the engraving path is not smooth.

If this is the reason, you can change the engraving machine's own parameters. If it is a circular orbital engraving machine, it is best to change the guide rail or slider. If it is a square track engraving machine, you should adjust the upper and lower trajectories and the front and rear sliders.

At the same time, if the linear speed and the curve speed of the engraving machine are too different, the engraving path will be deviated and the lettering will not be smooth.
 
If this is the case, it is necessary to change the linear speed and the curve speed. Of course, it is also necessary to change according to the engraving machine's own parameters.

What should I pay attention to when the engraving machine is used up?

The engraving machine belongs to a combination process from the principle of processing. Usually people can use engraving machines to engrave some relief artwork or perform large-scale cutting work. In short, with this engraving machine, it can save a lot of manpower, and it can also improve work efficiency. Next, let me introduce what should be noted after the engraving machine is used.


First, the drive system needs to be lubricated
Generally speaking, the engraving machine runs continuously when it is used, which means that it is used for a long time. In this case, after the use of the engraving machine, it is necessary to pay attention to the lubrication of the transmission system. Only in this way can the next use of the transmission system be guaranteed. When adding lubricant to the drive system, first pay attention to clean up.

Second, after using it, be sure to cut off the power
After the use of the engraving machine, it is necessary to pay attention to it, that is, to cut off the power in time. The usual measure to cut off the power supply is to look at the monitor of the engraving machine for display. It must be ensured that the monitor of the engraving machine has no display and the main circuit power indicator is off. This can explain the real cut off of the power supply.

Third, need to check some parts
Generally speaking, after the engraving machine is used, the user also needs to carefully inspect the parts of the engraving machine every three months or so. At this time, the main inspection items, look at the connection screws on both sides of the gantry are loose. If looseness occurs, tighten the measures in time.