Laser engraving machine production and processing considerations?

1. When using the laser engraving machine, be sure to check whether the facilities in the surrounding environment are safe, and also ensure the personal safety of the operators. Strictly follow the operation procedures.

2. When the machine is working, pay attention to check the water condition and water temperature of the chiller behind the machine.

3, do not expose the laser tube, so as not to break, it is easy to hurt people.

4. Avoid the influence of strong electricity, strong magnetism, etc. on the equipment, because it will affect the transmission of the signal.

5, in the power supply must be kept stable, under normal circumstances, if the voltage is very large, then there will be damage to the laser engraving machine, so it is best to use a voltage regulator.

6, it is best not to work in a strong acid, alkali environment for a long time, it will damage the fuselage and some fine parts.

Maintenance measures for laser engraving machine production and processing?

1, the first is the cleaning of the water tank: the water tank is recommended to use pure water, and the temperature should not exceed 35 ° C, if it is more than necessary to change the water or cool down. Remember to turn off the power before cleaning the water tank to avoid accidental electric shock. Then unplug the water pipe from the water inlet, let the water in the laser tube automatically flow back into the water tank, then open the water tank, take out the water pump, and clean the dirt on the pump. Clean the inside of the water tank and install it back as it is. First, power the pump separately and run it for a few minutes, mainly to fill the laser tube with water.

2, clean the fan: the fan has been known, the fan has been used for a long time, whether it is the outer mesh cover or the inside of the blade will have very thick dust, which will lead to small wind, no power, and there is abnormal noise. The fan of the laser engraving machine is the same, and it needs to be removed regularly to clean the dust on the blades and the net cover.

3, clean the lens: laser engraving machine has three reflective lenses and a focusing lens, the laser is reflected by the lens, after focusing from the laser head. Because the lens is on the outside, it is easy to get dust and dirt. If it is not clean, it will easily cause lens loss. Therefore, it is best to wipe the outer lens every day, remove the lens after two or three days, and wipe it with the cleaning solution. It does not take long. However, it can effectively improve the service life of the lens.

4, clean the rail: it is recommended to clean 2 to 3 times a month, remember to shut down the operation. The guide rail and the linear shaft are one of the core components of the equipment. During the processing, the processing material will generate a large amount of dust. These dusts will cover the surface of the guide rail and the linear shaft in a large amount, which will affect the precision of the processing of the equipment and will cost the equipment. Use time limit, in order to make the equipment work normally, use it for a long time, then pay attention to daily cleaning and maintenance.

5. Check the tightening of the screws and couplings. The vibration generated by the machine will loosen the screws and couplings at the joints, thus affecting the smoothness of the machine. Therefore, use the tools to tighten the screws one by one at regular intervals.

6. Checking the optical path: The piping system is completed by the mirror of the laser engraving machine and the focusing mirror. The focusing mirror in the optical path does not produce an offset, but the mirror may be offset because it is mechanically fixed. Under normal circumstances There is no offset, but it is recommended to check if the optical path is working properly and whether there is an offset before each work.