The main purpose of the engraving machine and the difference between the control methods

The main purpose of woodworking engraving machine:
Mainly used for wood processing, making it more beautiful. There are many types of woodworking engraving machines, and there are many brands, which leads to uneven prices.
The woodworking engraving machine is divided into three control modes: First, all the calculation work is completed by computer control. When the engraving machine is working, the computer is in working state, and other typesetting work cannot be performed, which may cause waste due to misoperation of the computer;
The second is the use of single-chip control, the engraving machine can work at the same time can be typeset, but can not turn off the computer, can reduce the waste caused by computer misuse;
The third is to use the USB port to transfer data. The system has a memory capacity of more than 32M. After saving the file, you can completely disconnect the computer, turn off the computer or perform other typesetting, which can greatly improve the work efficiency.

How to do the rust of the woodworking machine spindle motor?

The rust of the woodworking engraving machine spindle is a problem that plagues many users. Because of the working environment, if the maintenance is not timely, the spindle motor is easy to rust, and slight rust does not affect the normal use of the spindle motor, but if it is not handled for a long time, the life of the spindle motor will be shortened. Woodworking engraving machine spindle motor rust removal method:
First, by hand knocking, shovel, scraping, brushing, sand or flexible frustration to eliminate the appearance of scale, scale, etc., this is the painter radical derusting method, you can also use a blade, scraper, pointed hammer, wire brush , abrasive cloth, broken saw blade and other tools, this method is relatively simple, but it is also easy to damage the machine. Maintenance personnel need to be very careful when removing rust. It is easy to cause the machine spindle to deviate from the track without paying attention.
Second, use a clean lubricant, evenly sprayed on the motor, about half an hour you can use a cotton cloth to wipe off the rust on the stone engraving machine, if the rust is severe, you can spray a few times more lubricant. Lubricating cleaners are non-conductive and have good lubrication.